Vmx Jinstall-vmx-14.1r1.10-domestic
Has anyone been able to get this FULLY (function-wise) running on/in KVM in Ubuntu 14.4.3 LTS? That is, is it possible to be able to ping out from one of the 10 1GE intf's to external interfaces? I can ping out when I explicitly set the next hop MAC addr. Otherwise I cannot.
VMX beta - posted in JUNIPER SHARES: funabashi, on, said: The ge-0/0/0 is that the network adapter 1? I did try to bridge that one and set it as same network as my eth0 but it can't reach it. You need to change the mac addresses of ge-0/0/, read the document.
My Ubuntu VM is running in a vmware vm running on ESXi 5.5. There may be an issue with one of the dependent python scripts that vmx.sh -bind-dev uses. Just a remark, BTW. When you chase down the interfaces with tcpdump -i, then there is an issue between the Junos ge-0-0-0 (say) interface and the vmxlink bridge. (My setup is using 20 GB of RAM and it seems not to matter whether E1000 or VMXNET interfaces are used.)The question becomes, if vMX in KVM on Ubuntu cannot be run on ESXi, then what are people using? KVM enabled in an Ubuntu VM in Virtual Box?Edited by encimaDeIca, 09 December 2015 - 07:21 PM.
Vmx Jinstall-vmx-14.1r1.10-domestic 100
This guide is based on version: EVE Image NameDownloaded FilenameVersionvCPUsvRAMvmxvcp-17.1R1.8-domestic-VCPvmxvcp-17.1R1.8-domestic-VFPvmx-bundle 17.1R1.8.tgzJunos:17.1R1.8VCP-1VFP-3VCP-1GbVFP-4GbThis how to is tested for image versions 16.1, 16.2, 17.1.The NEW Juniper vMX images are based on dual nodes setup, where Routing engine (VCP) is connected to Forwarding plane (VFP) and act like single node. All cli configurations will be done on the VCP, but porting and connections will be on VFP.Create temporary working directory for images. Mkdir tmpcd tmpUpload the downloaded image to the EVE using for example.